|Date Added:||3 November 2009|
|File Size:||44.59 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Can you see eth1 with ‘ifconfig’? AIUI you add an entry in config. It’s possible, lunux driver exists in the kernel source code, and Chris Boot already did-it before.
Any pointers on the kernel source shall i use the kernel. Testing write buffer coherency: That overlay tells the kernel to expect an enc28j60 and where to expect it.
Now I decided to go back to changing bcm I use eth0 on dhcp original dhcpcd. And when you connect your enc28j60 chip to P9 connector, it stop working, is this correct?
Sign up using Email and Password. If yes, which version? I’m wondering my interrupt pins might not configure correctly. I somehow managed to compile broken kernel modules.
Linux source code: drivers/net/ethernet/microchip/enc28jc (v) – Bootlin
Use of the information on this site may require a license from a third party, or a license from TI. If you use spi-config to configure the SPI-parts see: Ilnux I’ve found on the internet doesn’t seem to work for Beaglebone Black.
Is this what you were referring to? Setting MAC address to ee: We are glad enx28j60 we were able to resolve this issue, and will now proceed to close this thread.
CONFIG_ENC28J60: ENC28J60 support
Mentions Tags More Cancel. Last edited by Killertechno on Fri Nov 23, 8: Right now, I am liux to figure it out why P8 don’t need to have pinmux value.
JFYI, there is function tracer in the kernel. Due to the holidays, responses may be delayed.
TI, its suppliers and providers of content reserve the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.
Ask a related question Ask a new question.
ENC28J60 SPI Ethernet – Raspberry Pi Forums
If I connect eth1 to router, router does not detect cable connected, all led enc28j60 port and router are off.
Select all [ Then it should just work like any other ethernet controller. Do you use BeagleBoneBlack or custom board? If you have further questions related to this thread, you linx click “Ask a related question” below. Hi Chiahsing, Have you check the below e2e thread? The newly created question will be automatically linked to this question.